JVC HR-J633U - Manual (Page 37)

37
SPECIAL FEATURES
TV Multi-Brand Remote
Control
In addition to controlling several functions on JVC remote
control TVs, the VCR's remote control can control these
functions on the TV brands listed below.
Before you start . . .
● Turn the TV’s power on using its remote control.
● Set the remote control’s TV/CABLE/VCR switch to TV.
1 2
4 5
3
6
8
0
7 9
POWER
NUMBER
ENTER
CH
VOL. +/-
TV/VIDEO
STOP
TV/CABLE/VCR
SET TV BRAND CODE
1
Refer to the chart below. While holding down POWER,
enter your TV’s brand code using the NUMBER keys,
then press STOP.
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● PANASONIC has two codes. If the TV does not
function with one code, try entering the other.
TRY OPERATING TV
2
Press POWER on the remote to turn off the TV’s power.
If it goes off, try other operations.
● The POWER, TV/VIDEO, CH5∞, VOL +/– and
NUMBER keys on the remote can all be used to
operate the TV. *For some brands of TV, you must
press ENTER after having pressed the NUMBER keys.
● To return the remote to VCR control, set the TV/
CABLE/VCR switch to VCR.
NOTE:
Depending on the kind of TV, there may be cases where some
or all functions cannot be operated using the remote control.
TV BRAND NAME BRAND CODE
JVC 01
MAGNAVOX 02
MITSUBISHI 03
PANASONIC 1 04
RCA 05
SHARP 06
SONY 07
TOSHIBA 08
ZENITH 09
HITACHI 10
PANASONIC 2 11
SAMSUNG 12
SANYO/SEARS 13