Jwin JK-333 - Manual (Page 7)

PROGRAMMED PLAYBACK
1. In stop mode, press the PROGRAM BUTTON "0" (flashing) wil show on the display
and the program indicator will flash.
2. Press the FAST FORWARD or REVERSE BUTTON to make track selection.
3. Press the PROG BUTTON again to store the selected track number.
4. Repeat steps 2 and 3 above to program other tracks.
5. Press the PLAY/PAUSE BUTTON to start programmed playback and the program
indicator will on.
6. To erase the programmed, press the PROG BUTTON and press the STOP
BUTTON once or open the CD door.
NOTE: Maximum of 19 tracks can be programmed to play in any order.
SPECIFICATIONS:
Power Source : 120V/60Hz
Speaker Impedance : 3½" 8 ohm
Output Power : 1.5W x 2 R.M.S.
CD
Frequency Response
: 100 - 16,000 Hz
Sampling Frequency : 44.1 KHz
Tape
Frequency Response
: 100 - 8,000 Hz
Tape Speed : 4.75 cm/sec.
TROUBLE SHOOTING GUIDE
The unit does not operate
• Is the AC power cord connected to a power outlet and fully inserted?
• Is the unit turned on? Rotate the FUNCTION switch from the OFF position to turn
on the unit.
No radio
• Is the FUNCTION switch in the correct position?
Turn FUNCTION switch to Radio.
• Adjust the VOLUME knob.
• Rotate the TUNING knob to find a radio station.
6