Playing back tapes – JVC UX-P3 User Manual
Page 20
– 15 –
English
Playing Back Tapes
You can play back type I, type II, and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press
0 for cassette deck.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE
2
2
2
2
2 3
3
3
3
3.
The unit automatically turns on and the tape
play starts. The tape direction indicator
(
3 or 2) flashes slowly on the display.
• Each time you press the button, the tape direction
changes.
3
3
3
3
3 : plays the front side.
2
2
2
2
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to or . (See “To
play both sides — Reverse Mode.”)
To stop playing, press
7.
To fast-wind to the left or to the right, press
¢ or 4
while the tape is not running.
The tape direction indicator (
3 or 2) starts flashing quickly
on the display.
To remove the cassette, press
0 for cassette deck.
To play both sides — Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE on the unit.
• Each time you press the button, reverse mode
changes as follows:
:
The deck automatically stops after playing both
sides of the tape. (Stops when playback in the
2 direction is finished.)
:
The deck continues to play both sides of the
tape until
7 is pressed.
:
The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
REV.MODE
TAPE
EN12-15.UX-P3[[UB]
01.3.27, 9:53 AM
15