beautypg.com

JBL EON15 G2 User Manual

Page 16

background image

The speaker connected to the

MIX/LOOP SWITCH set

Disengage the MIX OUT switch.

OUT connector goes up in

improperly

See the CAUTION in thedown in

volume when I adjust the INPUT

“Switches” section of this

1 control on the first speaker.

manual.

Speakers feed back and howl

Microphones are pointed into the

Move the speakers so they do

when the microphone volume is

speakers

not point the microphone’s

turned up

pickup pattern.

Equalizer settings are incorrect

Locate the feedback frequency
and reduce it using the mixer EQ
or an external equalizer.

Excessive gain

Reduce the gain at the mixer and
move the microphone closer to
the sound source.

Noise or hiss heard at output

Noisy source device

Disconnect the devices that are
connected to your speaker one
at a time. If the noise goes away,
the problem is with the source or
the connecting cable.

Hum or Buzz that increases or

Improper A/C ground or faulty

Disconnect or mute channels one

decreases when the mixer level

equipment connected to mixer

at a time to isolate the problem.

controls are moved.

input

Refer to the owner’s manual of
the faulty equipment for
troubleshooting help.

Faulty cable between source

Substitute a known-good cable

equipment and mixer

for the suspected faulty cable.

Hum or Buzz

Improper A/C grounding, ground

• “Telescope” the audio

loops

ground by using an XLR/F to
XLR/M adapter on one end.

• Re-route audio cables away

from AC power and lighting

cables.

Excessively long unbalanced

• Use the balanced outputs (if

cable run

available) of your mixer or

source equipment to drive

your EON speakers.

• Use a “DI” (direct injection)

box to convert your
unbalanced equipment output
to a balanced output.

Improper system gain structure

Reduce the INPUT 1, 2 and 3
controls and increase the output
level of your source devices.

The inputs from INPUT 2 and

MIX/LOOP SWITCH set

Set the MIX/LOOP SWITCH to

INPUT 3 aren’t coming out of

improperly

the MIX OUT position

the OUT connector

(depressed). See the CAUTION
in the “Switches” section of this
manual.

16