Jensen JMC-180 - Manual (Page 14)

E-13
wipe the disc from the center outwards with a good soft cleaning cloth.
TROUBLESHOOTING GUIDE
If you experience difficulties in the use of this music system please check the following or call 1
800 777 5331 for Customer Service and Support.
Symptom Possible Cause Solution
Noise or sound distorted
on AM or FM broadcast - Station not tuned properly for AM or
FM.
- FM: FM Wire antenna is not
extended.
- AM: The bar antenna is not positioned
correctly
- Retune the AM or FM broadcast
station.
- FM: Extend the FM Wire antenna.
- AM: Reposition the unit until the best
reception is obtained.
AM or FM no sound - Unit not in “RADIO” function mode.
- Volume set at minimum - Slide FUNCTION SELECTOR to
“RADIO” position.
- Increase Volume.
CD player will not play - Unit not in CD function mode.
- CD is not loaded properly.
- If the CD is self-compiled, the media
used may not be compatible with the
player.
- Select CD function mode.
- Load CD with label side up.
- Use better quality blank media and
retest.
CD skips while playing - Disc is dirty or scratched. - Wipe CD with clean cloth or use
another disc.
Intermittent sound from
CD player - Dirty or defective disc
- Dirty pick up lens
- Player is subject to excessive shock
or vibration
- Clean or replace the defective disc.
- Use a CD lens cleaning disc to clean
the lens.
- Relocate the player away from
shock or vibration.
Sound appears
distorted at high volume
levels - Volume control is set to maximum. - Adjust Volume Control to a lower
comfortable level.
No Alarm Alarm is not activated Check that Alarm indicator “ ” appears in
the Display.
Incorrect Alarm time Make sure AM or PM is set correctly.
90 DAY LIMITED WARRANTY AND SERVICE
VALID IN THE U.S.A ONLY