JVC GV-HT1U - Manual (Page 18)

18
EN
SUPPLYING THE POWER
Charging the battery
Use the provided AA-V68 AC adapter/Charger for charging the battery. Batteries that have not
been completely depleted can also be charged.
•Approximate charge time
→
Approx. 90 min for each BN-V607 battery
•Charging not possible
→
Charging is not possible when the DC cord is
connected to the AC adapter.
•Number of prints per battery charge
→
40 prints for each BN-V607 battery (at room
temperature)
NOTES :
• If you connect the DC cord to the AC adapter during battery charging, power is supplied to the printer
and charging stops.
• When charging the Battery for the first time or after a long storage period, the Charger Indicator may not
light. In this case, remove the Battery from the AC Power Adapter then try charging again.
• Since the AC Power Adapter processes electricity internally, it becomes warm during use. Be sure to use
it only in well-ventilated areas.
• If the battery operation time remains extremely short even after having been fully charged, the battery is
worn out and needs to be replaced. Please purchase a new one.
1 CONNECT AC ADAPTER/CHARGER
•Connect the power cord to a wall outlet.
2 INSERT THE BATTERY
•The charge indicator starts to blink.
•Charging has completed when the indicator
stops blinking and is on continuously.
3 REMOVE THE BATTERY
•Remove the power cord.
DC output terminal
AC Adapter/Charger
AA-V68
Power cord
Charge indicator 2
(Blinks during charging
→
Lights continuously when charging completes.)
Power lamp
Battery BN-V607
To AC outlet
Charge
indicator 1
3
2
1
Place side with
and symbols
face down.