Jwin JT P531 - Manual (Page 16)

Caller ID Speaker Phone V10M10_IM_EN_03232007
www.jWIN.com - 15 -
OPERATIONAL INSTRUCTIONS
Using the Last Number Redial Function
1. Remove the handset from base and listen for dial tone.
2. Use the [REDIAL/P] button redial the last number dialed (typically most helpful
when the line is busy).
Receiving Caller ID Information
Your telephone service provider must offer caller ID service in order to activate the
caller ID function on this unit.
1. Incoming Call Display.
• When there is an incoming call, the LCD will display the number, area code,
name, time and date of the call.
2. Make note of the following indicators.
• “UNKNOWN NUMBER”: The call is made through a telephone company
that does not offer caller ID service or does not transfer such information
long distance.
• “BLOCKED NUMBER”: Some areas allow callers the option of preventing
their telephone data from display on other telephones.
• “MESSAGE WAITING”: This will appear if you have a message service
through your telephone service provider and someone has left a message.
Reviewing the Caller ID List
Press [ ▲ ] or [ ▼ ] to review incoming calls (up to 94 calls).
VIP Function
1. When reviewing the caller ID list using [ ▲ ] or [ ▼ ], press [VIP] to store a
specific number from the list into the VIP record.
2. Press [VIP] again to cancel the VIP function.
Note: The number cannot be deleted from the caller ID list once it has been saved to
the VIP record.
Erasing Data from the Caller ID List
1. Press [ ▲ ] or [ ▼ ] to find the number
you wish to erase.
2. Press [DEL] to erase the number from
the list.
3. Press [DEL] for approximately 3
seconds for the LCD to show “ERASE
ALL?”
4. Press [DEL] again to erase the entire
caller ID list.