JBL 2.4G - Manual (Page 5)

5
NOTES: For the sake of simplicity, throughout this manual we have used the
term “source” when describing connections and operation. This would apply
to any device such as an A/V receiver, audio component, computer or portable
music player.
The JBL On Air Control 2.4G is designed for use in most countries worldwide,
depending upon local regulations. It includes 120V – 230V, 50/60Hz universal
power supplies for the transmitter module and the active speaker. While we
have included the two most commonly used AC cords with this product, your
AC electrical outlet may require the use of a different AC cord. For your safety,
it is essential to use an AC cord that is fully compatible with your local electri-
cal system. When in doubt, please consult your local JBL dealer or distributor.
The JBL On Air Control 2.4G may be connected to your source in several ways.
First, determine how you would like to use the JBL On Air Control 2.4G; then
follow the setup instructions for that application.
Application 1
Adding surround speakers to a home theater system.
Continue reading the instructions for Application 1 below.
Application 2
Adding speakers to remote locations around your home.
Application 1
Adding surround speakers to a home theater system:
Determine if your source contains preamp outputs for rear/surround channels,
usually indicated by RCA-type jacks on the back of the receiver labeled as
“surround preout” (please refer to your source’s owner’s manual to confirm
whether it includes the preamp outputs). If your receiver includes these
outputs, follow the steps below. If not, connection is not recommended.
NOTE: Make sure power is turned off on all components.
Step 1.
Connect the interconnect cable (included) to the left and right surround/rear
preamp outputs on the back of your source and the input on the transmitter
module D, as shown in Figure 1.
Step 2.
Determine the location of the surround speakers.
Figure 2. Place the active (left) speaker in the recommended location for the
left surround speaker.
Left
Surround
Channel
Right
Surround
Channel
Left Front
Channel
Subwoofer
Right Front
Channel
Center
Channel
Left Rear
Channel
Left
Surround
Channel
Right
Surround
Channel
Right Rear
Channel
Center Rear
Channel
Left Front
Channel
Subwoofer
Right Front
Channel
Center
Channel
Couch
Figure 1.
INPUT RL
R L
ID
CODE
1234
RECEIVER/PROCESSOR
Surround Channel
Preamp Outputs
CONNECTIONS