Jura Capresso E30 - Manual (Page 11)

11
Important: When steam is first drawn off, there is a possibi-
lity of spattering. The pivoting nozzle becomes hot. Avoid
direct contact with the skin.
8.1 Resetting to stand-by status
Ⅲ Place a container under the pivoting nozzle (13).
Ⅲ Turn selector switch for hot-water/steam (12) to position .
Ⅲ Push button
and draw off water until water-flow is automa-
tically stopped. Warning lamps , , , flash.
Ⅲ Then turn back selector switch for hot-water/steam (12) to posi-
tion .
Tip: Whenever you have finished drawing off steam clean
the pivoting nozzle with a damp cloth.
9. Drawing off hot-water
Ⅲ Place a cup under the pivoting nozzle (13) and turn selector
switch for hot-water/steam (12) to the symbol .
Ⅲ Press button . The machine will now deliver hot-water.
Ⅲ To stop this process turn back selector switch for hot-water/
steam (12) to the sympol .
Important: When hot-water and steam are first drawn off,
there is a possibility of spattering. The pivoting nozzle beco-
mes hot. Avoid direct contact with the skin.
10. Switching off machine
When the machine is switched off, the rinsing program is auto-
matically run again. Place an empty cup under the coffee-spout and
press button. When the rinsing water has run into the cup, the
machine powers down. Discard the water.
11. Care and maintenance
11.1 Fill water
When warning lamp lights up no more coffee can be drawn off.
Top up water as described in chapter 3.3.
11.2 Empty grounds container
Coffee grounds are collected in the grounds container. When
warning lamp
lights up, all coffee buttons are blocked and you
must empty the grounds container.
Ⅲ Push up coffee-spout (9).
Ⅲ Remove drip tray. Do this carefully as there is water in it.
Ⅲ Remove and clean drip tray (Fig. 6) and grounds container. First
replace grounds container and then drip tray (Fig. 7).
Important: Whenever grounds container is emptied, empty
drip tray too.
11.3 Drip tray is missing
If the drip tray is not replaced correctly, warning lamp flashes.
Note: When the drip tray is outside the machine you can take
the opportunity to clean the inside of the machine. Wipe off
any of coffee powder with a damp cloth. Then replace clean
drip tray.
11.4 Clean machine
After coffee etc. has been drawn off 200 times or 160 rinse
programs have been run, the machine must be cleaned. Warning
lamp
will remind you. You can still draw off coffee and hot-
water/steam. However we recommend that you clean the machine
(as described in chapter 12) within the next few days. Warning
lamp
does not go out until the complete cleaning process has
been carried out.
E