Jack Lananne's Power Juicer power juicer - Manual (Page 8)

POWER JUICER ELITE
8
Assembly/Main Unit
STEP
4
:
Place blade inside filter, centered
over screw peg. Using orange
crescent tool, place its pegs
into the holes on the blade.
Turn clockwise while holding
the filter and receptacle in place
until tight (as shown).
STEP
6:
Place lid with built-in pulp guard on top
of receptacle, making certain it is snugly
aligned with the pulp guard facing in
the opposite direction of the juice spout.
STEP
5
:
Place the pulp collector so that it rests
under the backside of the juicer.
POWER JUICER ELITE
IMPORTANT: There are MIN/MAX arrow markings on the
orange rim of the filter. These markings prevent you from
overtightening or undertightening the blade. Crescent
tool should line up between MIN/MAX arrows (as shown).
C CA AU UT TIIO ON N: : Remove crescent tool and set
aside. Do not leave tool inside juicer.
Note: Refer to page
6 for all part names.
Main Unit
Micro
Safetyswitch
Assembly Assembly
IMPORTANT: There is a Micro Safetyswitch located
in the back center of the pulp collector base.
This mechanism is an added safety feature.
Once the pulp collector is in place it
activates the Micro Safetyswitch.
This will protect you from
accidentally putting hands or
fingers under the machine while
the blade is spinning. Once the
pulp collector is removed from
the main base the motor will
not run.
Micro
Safetyswitch
MIN/MAX
Arrow Markings
Filter
Crescent Tool