JVC VCR PLUS+ DR-MV1S - Manual (Page 68)

Filename [DR-MV1SU_09Editing.fm]
Masterpage:Left+
68
EN
Page 68 March 16, 2004 4:27 pm
EDITING
You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.
1
Make connections.
A When recording on DVD deck
1) If the another recorder has no S-VIDEO connector, connect the
unit’s AUDIO/VIDEO INPUT connectors to the audio/video output
connectors on another recorder.
2) If the another recorder has S-VIDEO connector, connect the
AUDIO INPUT and S-VIDEO INPUT connectors to the audio and
S-video output connectors on another recorder.
● If connecting a unit with an S-VIDEO connector, it is recommended to
use an optional S-Video cable to minimize picture degradation while
editing.
B When recording on VCR deck
1) Connect the unit’s AUDIO/VIDEO INPUT connectors to the
audio/video output connectors on another recorder
2
Press VCR/DVD repeatedly to select the recording deck.
3
Press CH +/– to select “L-1” when using this unit as the
recording deck.
For DVD deck
● Set “REAR AUX L-1” to “VIDEO” for the VIDEO input connector, or
“S-VIDEO” for the S-VIDEO input connector, depending on the
connector being used. (
੬ pg. 74)
4
Press REC MODE repeatedly to set the recording mode.
5
Engage the Play mode of the source player.
6
Engage the Record mode of the recording deck.
7
Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you use this unit as the source player for editing, be sure to set
“SUPERIMPOSE” to “OFF” before starting. (
੬ pg. 74)
Edit To Or From Another Recorder
1
Player
Your unit
Another recorder
Recorder
TV receiver
A When recording on the DVD deck:
1
Recorder
Your unit
Another recorder
Player
TV receiver
B When recording on the VCR deck:
Slide the TV/CABLE/DBS/DVD switch to DVD.
DR-MV1SU_09Editing.fm Page 68 Tuesday, March 16, 2004 4:28 PM