Jensen CD-545 - Manual (Page 9)

8
CD PLAYER OPERATION
Note: This CD player will not only play commercial CDs, but also self-compiled CD-R/RW discs.
Do not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.
Notes on CD-R/RW Discs
x Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance are not guaranteed.
x Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions
such as PC performance, writing software, media ability, etc.
x Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
1. Open the CD Door by pressing the CD Door (#4) where indicated PUSH OPEN/CLOSE.
2. Carefully place an audio CD with its label side upward in the CD compartment and close the
CD Door by pressing on the CD Door (#4) where indicated PUSH OPEN/CLOSE.
3. Set the Function Selector (#1) to the "CD" position. The POWER Indicator (#16)
will light. The LED Display (#13) will briefly display flashing “- -”and then the total
number of tracks on the CD will appear in the LED Display (#13) after a few
seconds.
4. Press the CD PLPA/PAUSE Button (#12). The CD Play/Pause Indicator (#15)
will light and the CD will start playing from the first track.
5. Adjust the Volume Control (#5) to obtain the desired sound level from the Built-in
Speakers.
6. To enhance the bass effect, depress and release the BASS Button (#26) when a “click” is
heard.
7. To suspend playing, press the CD PLAY/PAUSE Button (#12) and the CD
Play/Pause Indicator (#15) will flash.
To resume playing, press the CD PLAY/PAUSE Button again.
8. You can choose to play your favorite track directly by pressing either the Skip Forward
Button (#7) or Skip Backward Button (#8). The LED Display (#13) will indicate
the correct track number selected.
9. To locate a particular passage within a track, keep the CD Search Forward Button (#7)
or CD Search Backward Button (#8) depressed until it is found.
10. To repeat a particular track, press the CD REPEAT Button (#10) until the CD
Repeat 1/All Indicator (#14) flashes.
11. To repeat the entire CD , , , press the REPEAT Button (#10) until the CD Repeat 1/All
Indicator (#14) lights steadily.
12. To stop playing, press the CD STOP
Ŷ
Button (#11).
13. When you wish to turn off the CD Player, set the Function Selector (#1) to the "TAPE" position.
The POWER Indicator will go off.
CD PROGRAMMED PLAY
This function allows the tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1.
In CD stop mode, press the PROGRAM Button (#9) once. Program No. “01”
will appear and blink in the LED Display (#13).
2. Press the CD Skip Forward Button (#7) or CD Skip Backward Button
(#8) to select the song to be programmed. For example track 5 is selected.