JVC ShowView LPT0923-001A - Manual (Page 45)

Masterpage:Right+
EN
45
Filename [DR-MH30EU_07Timer Recording.fm]
TIMER RECORDING
Page 45 Friday, 11 June 2004 21:18
Weekly/Daily Recording
You can record programmes with one of the following weekly/daily
timer settings.
For the HDD deck
When you select a mode other than ONCE, the space on the hard
disk drive is saved for new recordings by overwriting previous
recordings. To prevent loss of a needed recording, backup
programmes you wish to save by dubbing them to DVD discs
before overwriting previous recordings.
ONCE (One Time Recording)
In this mode a programme will not be automatically overwritten.
WEEKLY (OVERWRITE) (Weekly Recording/Weekly Overwrite)
When the set weekly programme is broadcast, the programme
recorded last week is automatically deleted and overwritten by the
new programme.
MON–SUN (FOR A WEEK) / MON–SAT (FOR A WEEK) / MON–FRI
(FOR A WEEK) (Daily Recording/Weekly Overwrite)
When the set weekly programme is broadcast, the programme
recorded on the same day last week is automatically deleted and
overwritten by the new programme.
MON–SUN (OVERWRITE) / MON–SAT (OVERWRITE) / MON–FRI
(OVERWRITE) (Daily Recording/Daily Overwrite)
When the set daily programme is broadcast, yesterday’s
programme is automatically deleted and overwritten by the new
programme.
For the DVD deck
ONCE (One Time Recording)
WEEKLY (Weekly Recording)
MON–SUN / MON–SAT / MON–FRI (Daily Recording)
VPS/PDC Recording
Now available from some TV stations, PDC (Programme Delivery
Control) and VPS (Video Programme System) are services
designed to assure safe, accurate timer recording. With this
system, special code signals are transmitted together with the
audio/video signals. These code signals control your video unit and
have precedence over the advertised times you may have preset
into the timer. This means that your unit will start and stop
recording when the preset TV programmes actually start and end
— even if the broadcast time of a preset TV programme is
changed.
NOTES:
● Make sure to press VPS/PDC# after completing timer programming
procedure to activate the VPS/PDC recording function.
● When you use Manual Timer Programming, set the start time (VPS
or PDC time) exactly as advertised in the TV listing. A different time
than advertised will result in no recording.
● VPS/PDC recording is also possible when a satellite receiver or a
cable system is connected to L-2 IN/DECODER connector on your
unit.
● VPS/PDC recording is also possible via the L-1 IN/OUT connector.
How to check if the station being received transmits a VPS/
PDC signal
A Hold down DISPLAY for about 5 seconds. “VPS/PDC” appears
blinking on the front display panel. If a VPS/PDC signal is detected
from the station, “VPS/PDC” will stop blinking. If no VPS/PDC
signal is detected from the station, “VPS/PDC” will blink at a slower
rate.
B Press DISPLAY again to return to normal display.
Overwritten
This week’s drama
Last week’s drama
Overwritten
This
week
Last
week
MON TUE WED THU FRI
MON TUE WED THU FRI
Overwritten
Tuesday’s programme
Monday’s programme
DR-MH30EU_00.book Page 45 Monday, June 14, 2004 8:03 AM