JVC HR-J449MS - Manual (Page 18)

18
INITIAL SETTINGS (cont.)
Storing Channels Manually
Store channels that were not stored during Auto Channel Set.
ACCESS MENU PRINCIPAL
SCREEN
1
Press MENU twice.
ACCESS CONFIRMATION
SCREEN
2
Move the highlight bar (pointer) to "REGL.MANUEL
CANAUX" by pressing MULTI-FONCTIONS
%fi, then
press OK. The Confirmation screen appears.
SELECT POSITION
3
Press MULTI-FONCTIONS
%fi until an open position
in which you want to store a channel begins blinking,
then press OK. The Manual Ch. Set screen appears.
INPUT CHANNEL
4
The number "02" appears blinking to the right of "CH".
Press the NUMBER keys to input the channel number
you want to store.
● For fine tuning adjustment, press MULTI-FONCTIONS
until the item under "CH" begins blinking, then press
MULTI-FONCTIONS
%fi. While tuning, “F+” or “F–”
appears.
● If necessary, to change the band*, press MULTI-
FONCTIONS until CF begins blinking, then press
MULTI-FONCTIONS
%fi to select the band.
* The band indication changes as follows: CF (SECAM
L normal channel) → CA (SECAM L cable network)
→
CH (PAL or SECAM B/G normal channel)
→
CC
(PAL or SECAM B/G cable network).
● When storing a channel that sends scrambled
broadcasts, press MULTI-FONCTIONS until
"DECODEUR" blinks, then press MULTI-FONCTIONS
%fi to set "DECODEUR" to "M." ("A." is the default
setting).
ENTER NEW CHANNEL
INFORMATION
5
Press OK, and the Confirmation screen appears.
● Repeat steps 3 through 5 as necessary.
CLOSE CONFIRMATION
SCREEN
6
Press MENU.
● To input the station name, see page 20.
● To change positions, see "Change Station Channel
Position" (
੬
pg. 19).
Using The
Confirmation
Screen
1 2
4 5
3
6
8
0
7 9
2
4
1
3
MULTI-FONCTIONS
OK
%
fi
NUMBER
%
%
MENU
When Receiving A Scrambled Broadcast
Make sure that "SELECTION AV2" is set to "DECODEUR"
(
੬
pg. 49).
1– Perform steps 1 and 2 in the right column.
2– Press MULTI-FONCTIONS
%fi to select the
position of the channel broadcasting the scrambled
programmes, then press OK three times.
3– Press MULTI-FONCTIONS until "DECODEUR"
begins blinking, and set it to "M." by pressing MULTI-
FONCTIONS
%fi.
4– Press OK to access the Confirmation screen.
● Repeat steps 2 – 4 for each additional channel.
5– Press MENU.
% fi
%
%