JBL EON10 - Manual (Page 11)

11
Application Examples
One Piece PA System
In this basic PA setup a dynamic microphone is connected to INPUT 1. The MIC / LINE switch would be
set to the MIC position (depressed). Several examples illustrating possible uses for INPUT 2 & 3 are
shown.
Acoustic Electric Guitar - The mono or stereo output of an electrified acoustic guitar can be connected
directly to INPUT 2 & 3. If a stereo instrument and cable are used, the left and right channels will be
combined into mono.
Electronic Keyboards - A pair of electronic keyboards are connected to INPUT 2 & 3 via an adapter cable
(see the section “Cables and Connectors”). Such a cable is available from pro-audio dealers and is
commonly used as an “insert cable”.
Portable CD Player - A portable CD player may be connected to the EON10 G2 by means of a 1/4” TRS
to Mini-Phone adapter. Again, the left and right channels will be combined into mono.
LINE MIC
O
U
T
P
U
T
1
I
N
P
U
T
LOOP MIX
R-PEAK
G-SIGNAL
1
2 & 3
2 & 3
2
3
1/4” TS Phone
1/4” TS Phone
1/4” TS Phone
1/4” TS Phone
1/4” TRS Phone
1/4” TRS Phone
to
Mini-Phone
Adapter
1/8” TRS Phone
1/8” TRS Phone
Portable CD
Player
Acoustic
Electric
Guitar
Dynamic
Microphone
Electronic Keyboards