Controls, Installation – JBL MR-17 User Manual

Page 7

VOLUME

Select

BASS

Select

TREBLE

Select

FADER

Select

BALANCE

Select

Beep 2nd

I-Vol

Area

Press

DSP

Controls

1. POWER ON/OFF button (1)
Push the PWR button (1) to turn on the unit. Push the button again to turn off the unit.

2. SEL and VOL button (2)
1) Audio control ( VOLUME / BASS / TREBLE / BALANCE / FADER )
Short pressing the SEL (2) button you can select which of the below features to set:

-VOL display - volume control > press button (2)>
-BAS display - bass tone control >press button (2)>
-TRB display - treble tone control > press button (2)>
-BAL display - balance control > press button (2)>
-FAD display - fader control > press button (2)>

Then use the spindle knob(2) to adjust. In each mode, the waiting time is about 5 seconds.
If the waiting time is over, it returns to the last display mode of Radio, CD, or CDC mode.
These settings are indicated on the display window.

2) Beep 2nd , I-Vol , Area and DSP Selection
When the SEL button (2) is pressed over 2 seconds, the unit will be operated as below:

a. Beep 2nd
In the Beep 2nd mode, you can control Beep on or Beep 2nd by turning the spindle knob.
- Beep on : You can hear "beep" sound when you press any buttons.
- Beep 2nd :You can hear "beep" sound when you press a button over 1.5 seconds.

b. I-Vol
By pressing the SEL(2) button again, the unit will turn to I-VOL mode (Initial Volume Level
Adjustment). You can adjust the I-Vol to the level you want by turning the spindle
knob. After setting the initial level, when the unit is powered on/off, detached on/off, or
when the ACC is turned on/off, the I-VOL will keep the volume adjusted to the preset level
when unit is turned on.

1. Precautions
Choose the mounting location carefully so that the unit will not interfere with the
normal driving functions of the boat.
Avoid installing the unit where it would be subject to high temperature, such as from
direct sunlight or hot air, or where it would be subject to dust, dirt or excessive
vibration. Use only the supplied mounting hardware for a safe and secure installation.
Be sure to remove the front panel before installing the unit.

2. Mounting angle adjustment
Adjust the mounting angle to less than 20 degrees from horizontal.

3. Mounting example

<< Installation in the cabinet >>

Note: Keep the release key in a safe place as you may need it in future to remove
the unit from the boat.

Installation

Release Key

Half Cabinet

Tap

Bend these claws, if necessary.

4. Attaching the Trim Ring
- Attach the Trim Ring to the Radio after installing.
- Be sure to insert the Trim Ring in the correct direction.

8.DIS

PWR

2 INT

3 RPT

4 RDM

MODE

7.SCN

FLIP DOWN / COMPACT DISC PLAYER HI - POWER 4x45Watts

MR-17

0. LD

MUT

SH.
SR

BD/FN

MARINE

-1

-I