Dryer description, Control panel – Indesit ISL65C User Manual
Page 3
Installation
Description
Star
t and
Pr
ogrammes
Laundr
y
W
arnings and
Sug
g
estions
Maintenance and
Care
T
roub
leshooting
Ser
vice
GB
3
Dryer Description
replacing the empty container, the dryer must be
running for this to happen (
see The Controls
).
The
On/Off
indicator light signals that your dryer
is in use or ready to select a programme. If this light
flashes it indicates there is a fault (
see Troubleshooting
).
The
ON/OFF
button : If the dryer is running and
this button is pressed, the dryer stops. Press again,
the dryer restarts.
The
Progress or Delay
lights show you the status of
the programme, or the delay time when they flash.
During a delayed start the lights will flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (
see Start and Programmes
).
The
PROGRAMMES
knob sets the programme:
rotate it until the indicator is pointing to the programme
you want to select (
see Start and Programmes
).
The
START/CANCEL
button starts a selected
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. If you have not set a programme, the buzzer
will beep four times. When a programme is running,
holding this button in cancels the programme and
stops the dryer (
see Start and Programmes
).
The
OPTION
buttons/lights select available options
for your selected programme (
see Start and
Programmes
). The lights indicate that the option has
been selected.
The
Programmes Guide
allows you to consult a user
friendly table of the available programmes.
The
Empty Water
light signals that the water
container should be emptied. When it is flashing it
indicates that the container is full.
The light will take a few seconds to go out after
Control panel
Empty Water
Light
Programmes Guide
PROGRAMMES
Knob
START/CANCEL
Button
Indicator
OPTION
Buttons and lights
Progress or Delay
Lights
On/Off
Light
ON/OFF
Button
To open the door
The features
Press and release the front
panel in position shown
Water container
Air intake
grille
Rating plate
Door catch
Filter
Door latch
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover