Indesit DV 62 - Manual (Page 5)

3
GB
Salt, Detergent and Rinse Aid
Salt
The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with a special softener that uses
a salt specifically designed to eliminate lime and minerals
from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is
located beneath the
lower rack and should be
filled as follows:
1. Remove the lower rack
and then unscrew and
remove the cap from the
salt container;
2. If you are filling the
container for the first
time, fill it with water;
3. Place the end of the
funnel (supplied) into the
hole and introduce about 2 kg of salt. It is normal for a
small amount of water to come out of the salt container.
4. Carefully screw the cap back on.
The salt container should be filled after about every
30 wash cycles.
Warning: To prevent rust from forming , we advise you to
load the salt before beginning a wash cycle.
Detergent
Detergent specifically intended for use with dishwashers must
be used. The dispenser must be refilled before the start of
each wash cycle following the instructions provided in the
"Wash Cycle Table." The detergent dispenser is located on
the inside panel of the door.
Loading the detergent
To open lid "A", press button "B". The cleaning detergent
should be introduced into the two containers "C"and "D"
up to the rim, as indicated in the wash cycle table.
C
A
B
D
8 gr. 22 gr.
After pouring in the detergent, replace the lid, pressing down
until it clicks.
Dishwasher detergent in tablets is now available on the
market, in which case you should place one tablet into
container "D" and close the lid.
If you use powder or liquid detergent, you can also fit the 2
plugs provided in the two special housings in lid "A", before
closing the latter. This way, your dishes will come out cleaner.
Notice: To facilitate closing the cover, remove any
excess detergent on the edges of the dispenser.
Rinse Aid
This product makes dishes sparkle and helps them to dry
without spotting. The dispenser is located on the inside panel
of the door and should be filled after every 80 wash cycles
(or when the rinse aid indicator light comes on for those
models with this feature).
Loading the Rinse Aid
To open the dispenser, turn the "C" cap in the anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the "F" dose adjustor, located beneath
the "C" cap, with a screwdriver. There are 6 different
settings; the normal dosage setting is 4.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjustor should be turned to a higher setting. If
the dishes have white streaks, turn the dosage adjustor to a
lower setting.
C
F