beautypg.com

Image IMTL22506.0 User Manual

Page 9

background image

9

48

2

53

12

12. With the help of a second person, carefully raise the

Left Upright (53) and Right Upright (not shown), to a
vertical position. Attach the Storage Latch (48) to the
Left Upright (53) with two 3/4" Screws (2).

13.

Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 17). To pro-
tect the floor or carpet, place a mat under the treadmill.

11. Lower the Uprights (53, 62) until the Handrails (59) are

touching the floor.

See the lower drawing. Position the Uprights (53, 62) so
the treadmill Frame (79) is centered between them.

Firmly tighten the four Upright Bolts (65) and the two
Frame Bolts (70).

Be careful not to overtighten the

Frame Bolts.

53

53, 62

59

70

79

62

Top View

11

65

52

No

Screw

60

2

59

2

2

10. Set the Console (55) in the Console Base (52).

Make

sure that no wires are pinched. Insert as much of the
Wire Harness (60) as possible down into the hole in the
right Handrail (59).

Securely tighten the plastic tie

nearest to the right Handrail. Next, pull any excess
Wire Harness between the plastic ties tight, and tighten
the other plastic tie. Cut off the ends of the plastic ties.

Attach the Console (55) to the Console Base (52) with
five 3/4" Screws (2) in the locations shown.

Note: There

should not be a Screw in the hole indicated by the
arrow. Do not overtighten the Screws.

55

Ties

10