Icom IC-F3063T - Manual (Page 17)

6 - 5
6-3 TRANSMIT ADJUSTMENT
Select an adjustment item using [ ↑] / [↓] keys, then set to the specifi ed value using [←] / [→] keys on the connected PC's keyboard.
ADJUSTMENT ADJUSTMENT CONDITION
MEASUREMENT
VALUE
UNIT OPERATION
OUTPUT
POWER
[Power (Hi)] 1 • Channel
• Transmitting
: CH 3 Top
panel
Connect an RF power meter to
the antenna connector. 5.0 W
[Power (L2)] 2 • Channel
• Transmitting
: CH 4 2.0 W
[Power (L1)] 3 • Channel
• Transmitting
: CH 5 1.0 W
MODULATION
BALANCE
[BAL (Narrow)] 1 • Channel
• Preset [MOD Narrow]
: CH 13
: 60 Top
panel
Connect the FM deviation me-
ter to the antenna connector
through an attenuator.
Set to square wave form
• No audio applied to the JIG cable.
• Set an FM deviation meter same as;
HPF
LPF
De-emphasis
Detector
: OFF
: 20 kHz
: OFF
: (P–P)/2
• Push [P0] key while transmitting.
FM
DEVIATION
(NARROW)
[MOD N C] 1 • Channel : CH 13 Top
panel
Connect the FM deviation me-
ter to the antenna connector
through an attenuator. ±2.05 to ±2.15 kHz
• Connect an audio generator to the JIG
cable and set as;
Frequency : 1.0 kHz
Level : 150 mV rms
• Set the FM deviation meter to same condi-
tion as "MODULATION BALANCE."
• Transmitting
(NARROW)
[MOD N L] 2 • Channel
• Transmitting
: CH 8
(NARROW)
[MOD N H] 3 • Channel
• Transmitting
: CH 1
(WIDE)
[MOD W C] 4 • Channel
• Transmitting
: CH 5 ±4.05 to ±4.15 kHz
(WIDE)
[MOD W L] 5 • Channel
• Transmitting
: CH 6
(WIDE)
[MOD W H] 6 • Channel
• Transmitting
: CH 7
(MIDDLE) †
[MOD M C]
7 • Channel
• Transmitting
: CH 14 ±3.15 to ±3.25 kHz
(MIDDLE) †
[MOD M L]
8 • Channel
• Transmitting
: CH 15
(MIDDLE) †
[MOD M H]
9 • Channel
• Transmitting
: CH 16
DIGITAL
DEVIATION*
[MOD D C] 1 • Preset [Digital Mode] : 7 Top
panel
Connect an FM deviation meter to
the antenna connector through
an attenuator. ±1.41 to ±1.45 kHz
2 • Channel : CH 9
• Set the FM deviation meter to same condi-
tion as "MODULATION BALANCE."
• Transmitting
[MOD D L] 3 • Channel
• Transmitting
: CH 10
[MOD D H] 4 • Channel
• Transmitting
: CH 11
CTCSS/DTCS
DEVIATION
[CTCSS/DTCS] 1 • Channel : CH 12 Top
panel
Connect an FM deviation meter to
the antenna connector through
an attenuator. ±0.68 to ±0.72 kHz
• No audio applied to the JIG cable.
• Set the FM deviation meter to same condi-
tion as "MODULATION BALANCE."
• Transmitting
†
; [EUR-01] only.
*; Necessary only when the optional UT-119 is installed.