InFocus SP-CEIL-010 - Manual (Page 5)

S EE FIGURE 4
Wall wood stud
Wall structure
D
Adjustable extension
E
B
C
C
B
Adjustable screws
Wall Mount Installation
Complete the following steps to install the projector mount and projector to your wall. (F IGURE 4)
Note: Look at the bottom of the upper assembly (D) and locate the arrow. Make sure you install the projector
mount with the arrow pointing toward your screen.
NOTE: Follow step 3 to secure the extension to the mount assembly.
15. Secure the upper plate to the wall using the commercially available hardware (E) suitable for your
environment. Be sure that the screen indicator arrow is pointing toward your screen.
16. Carefully raise the projector (C) with the mounting bracket (B) attached and insert it into the bottom of
the mount assembly by its tabs.
17. Rotate the projector (C) with the mounting bracket (B) attached 180º so that the projector’s focus rings
is pointing toward your screen.
18. Align the safety knob on the mount assembly with the end of the arrow-shaped slot on the mounting
bracket (B) and screw it through the opening to prevent further rotation. Hand-tighten the securing
knob.
19. Hand-tighten the remaining two tension knobs to secure the mounting bracket (B) to the mount
assembly (D).
CAUTION: Check all of the hardware for proper tightness and security. Do not over-tighten the screws.
NOTE: Use the Allen wrench key (F) for the following modification
A
WARNING
When using the optional
extension adapters and making
a height adjustment while
secured to the wall or ceiling do
not remove the screws
completely from the extension.
Failure to do so could result in
injury and damage to the
projector.
5