IBM 3590 - Manual (Page 59)

Set Port 1 Address Menu
Table 14 shows the Set Port 1 Address menu.
Table 14. Set Port 1 Address
Function Next Menu
Cancel “Set Address Menu” on page 37
0 “Options Menu” on page 31
1 “Options Menu” on page 31
... “Options Menu” on page 31
F “Options Menu” on page 31
Note: Supplemental Message Line 1: Change made after Supplemental Message Line
2: next power on
Cancel
Causes the “Set Address Menu” on page 37 to appear.
Allows the operator to set the address of SCSI port 1. The value can
be from 0–15 (16 addresses).
Note: You must select Reset Drive from the Services menu, press the
Reset push button or switch off power to the device, then
switch on power to activate the new address.
Chapter 3. Drive Operator Panel and Controls 39