iHome iH36 - Manual (Page 9)

iH36 Mounting/Installation Instructions
Examples:
If your cabinet has no overhang, just use 4 of the 3 inch screws with no spacers
If your cabinet has a 1 inch overhang, use 4 of the 1/2" spacers, 4 of the 1" spacers and four 4 1/2" screws.
Table 1: SPACER/SCREW SELECTION CHART
Note: This unit is designed for cabinets with an overhang of 2 1/4" or less. If your cabinet has an overhang longer than 2 1/4",
please call a customer service representative at 1-800-228-2792.
8
Step 1. Measure the overhang height
Use a ruler or tape measure to determine the exact amount of overhang, if any.
Measure from the front inside bottom edge of the cabinet bottom straight down to
the end of the overhang (see figure 1) to determine the height of the overhang.
Step 2. Determine which spacers and screws to use
Once you have your overhang measurement, look at Table 1 and find the nearest
measurement in the Overhang column, then determine the combination of spacers
and screw size you need. Set them apart.
OVERHANG
Measure this distance to
select screw and spacer
combination (see chart)
Front of
Cabinet
(Figure 1)
Bottom Shelf
OVERHANG
0 - 3/8’’
1/2 - 3/4’’
7/8 - 1 3/8’’
1 1/2 - 1 3/4’’
1 7/8 - 2 1/4’’
None
1’’ spacer x 4
1/2’’ spacer x 4 +
1’’ spacer x 4
1/2’’ spacer x 4+
1’’ spacer x 8
3’’ x 4
3’’ x 4
4 1/2’’ x 4
4 1/2’’ x 4
4 1/2’’ x 4
SPACERS SCREW
1’’ spacer x 8