Image IMTL59105.1 - Manual (Page 6)

ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver , wire
cutters , adjustable wrench , and rubber mallet .
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic
parts, do not use power tools for assembly.
6
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (58) so the treadmill is more stable.
Do not fully
fold the treadmill until it is completely assembled.
Press a Base Endcap (44) into the indicated end of the
Upright Base (84). Make sure that the Base Endcap is
oriented as shown in the inset drawing. If necessary, use
a rubber mallet to insert the Base Endcap.
Attach two Base Pads (82) to the Upright Base (84) with
two 1” Tek Screws (83).
82
58
82
84
83
83
Wheel Nut (32)–2
1
Handrail Star
Washer (89)–4
Upright Bolt (65)–4
3
Silver Ground
Screw (94)–1 1” Tek Screw (83)–4
Handrail Bolt (64)–4
3
Upright Star
Washer (67)–4
Screw (3)–11
Wheel Bolt (81)–2
Wheel Spacer
(97)–4
84 44
44
1