Invacare TDX SP - Manual (Page 50)

SECTION 8—FOOTBOARD ASSEMBLY
TDX™ SP 50 Part No 1143190
SECTION 8—FOOTBOARD
ASSEMBLY
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that ON/OFF
switch on the joystick is in the OFF position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user’s feet
MUST remain on the footboard while operating the wheelchair. If the user’s feet
are allowed to rest off the side of the footboard they may come in contact with the
caster possibly resulting in injury.
Removing/Installing the Footboard
NOTE: For this procedure, refer to FIGURE 8.1 on page 51.
Removing
1. Remove the socket heat screw, three washers, spacer and locknut that secures the
footboard to the footboard support.
2. Remove the footboard from the footboard support.
Installing
ƽ WARNING
Pinch point may occur when rotating the footboard assembly.
1. Position the footboard onto the footboard support so that the mounting holes in the
wheelchair frame align with the desired mounting holes in the footboard support.
2. Using the socket heat screw, three washers, spacer and locknut secure the footboard
to the footboard support.