Image IMTL94106.2 User Manual
Page 8
8
68
5
Collar
Spring
114
55
Knob
132
3
Small
Holes
3. With the help of a second person, raise the treadmill
Frame (55). Hold the Latch Housing (68) and the Latch
Housing Cover (5) against the sides of the Frame as
shown. Loosely thread the two blunt-tipped 1/2” Screws
(132) into the Latch Housing Cover and the Latch Housing
as shown.
Do not tighten the Screws yet.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. The collar should be on the
side of the spring shown. Insert the pin into the Latch
Housing (68), and tighten the knob back onto it.
Align the pin with the hole in the Left Handgrip (3) by slid-
ing the Latch Housing (68) up or down. Make sure that the
pin can be inserted fully into the hole. Hold the Latch
Housing in place as you tighten two 1/2” Tek Screws (114)
into the Latch Housing and the Frame (55). Then, tighten
the 1/2” Screws (132). Note: It may be necessary to pull
on the knob to access and tighten the Screws.
5.
Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet. Note: Extra hardware may be included. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). For your benefit, we
recommend that you familiarize yourself with the TROUBLESHOOTING section on pages 23 and 24.
Hole
Pin
3
114
132
4. Note the location of the 75 ohm terminal near the power
cord. For the television to operate properly, a CATV cable
must be connected to the 75 ohm terminal (see page 9).
4
75 Ohm Terminal