beautypg.com

Image IMTL11905 User Manual

Page 27

background image

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key and

UNPLUG THE POWER CORD. If the walking belt has
shifted to the left,
use the allen wrench to turn the left
rear roller bolt clockwise 1/2 of a turn;

if the walking belt

has shifted to the right, turn the left bolt counterclock-
wise 1/2 of a turn. Be careful not to overtighten the walking
belt. Then, plug in the power cord, insert the key, and run
the treadmill for a few minutes. Repeat until the walking
belt is centered.

b. If the walking belt slips when walked on, first remove the

key and

UNPLUG THE POWER CORD. Using the allen

wrench, turn both rear roller bolts clockwise, 1/4 of a turn.
When the walking belt is correctly tightened, you should
be able to lift each side of the walking belt 3 to 4 inches off
the walking platform. Be careful to keep the walking belt
centered. Then, plug in the power cord, insert the key, and
carefully walk on the treadmill for a few minutes. Repeat
until the walking belt is properly tightened.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE

POWER CORD. Next, remove the screws from the hood
and carefully remove the hood. Locate the Reed Switch
(17) and the Magnet (12) on the left side of the Pulley (11).
Turn the Pulley until the Magnet is aligned with the Reed
Switch.

Make sure that the gap between the Magnet

and the Reed Switch is about 1/8”. If necessary, loosen
the indicated Screw (40), move the Reed Switch slightly,
and then retighten the Screw. Re-attach the hood and run
the treadmill for a few minutes to check for a correct speed
reading.

PROBLEM: The chest pulse sensor does not function properly

SOLUTION: a. If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROU-

BLESHOOTING on page 8.

b. If the chest pulse sensor still does not function properly, the battery

should be changed. To replace the battery, locate the battery cover
on the back of the sensor unit. Insert a coin into the slot in the cover
and turn the cover counterclockwise to the “open” position. Remove
the cover.

Remove the old battery from the sensor unit. Insert a new

CR 2032

battery, making sure that the writing is on top. In addition, make sure
that the rubber gasket is in place in the sensor unit. Replace the bat-
tery cover and turn it to the closed position.

b

27

12

17

40

Top

View

1/8”

11

a

Battery

Rubber

Gasket

Battery Cover

b

Battery

Cover

a