beautypg.com

Image IMBE41990 User Manual

Page 11

background image

15. Press a 50mm Square Outer Cap (17) onto each end

of the Small Stabilizer (25).

Attach the Small Stabilizer (25) to the Bench Frame
(5) with two M10 x 65mm Carriage Bolts (40) and two
M10 Nylon Locknuts (11). Note: There is an inden-
tation around the holes on one side of the Small
Stabilizer. This side must be facing the floor.

15

40

11

5

17

17

25

16. Press a 50mm x 70mm Outer Cap (10) onto each

end of the Large Stabilizer (26).

Turn the Large Stabilizer (26) so the warning decal is
in the position shown. Attach the Large Stabilizer to
the Bench Frame (5) with two M10 x 65mm Carriage
Bolts (40) and two M10 Nylon Locknuts (11). Note:
There is an indentation around the holes on one
side of the Large Stabilizer. This side must be fac-
ing the floor.

16

40

5

10

11

Decal

10

26

17. Press two 20mm x 40mm Inner Caps (28) into each

Backrest Tube (27). Press four 20mm x 40mm Inner
Caps into the Backrest Adjustment Bracket (36).

Lubricate an M10 x 180mm Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Backrest Adjustment Bracket (36) with the Bolt, two
M10 Washers (6), and an M10 Nylon Locknut (11).
Make sure that the Backrest Tubes are turned as
shown. The indicated holes are not centered in
the Backrest Tubes but are closer to one side.
Turn the Backrest Tubes so the holes are closer
to the floor. Do not overtighten the Nylon Locknut;
the Backrest Tubes must pivot easily.

18. Attach the Backrest Adjustment Bracket (36) to the

bracket on the Bench Frame (5) in the following way:

Lubricate an M10 x 115mm Bolt (55). Slide an M10
Washer (6) onto the Bolt and insert the Bolt through
the indicated tube of the Backrest Adjustment Bracket
(36).

Hold the Backrest Adjustment Bracket (36) over the
bracket on the Bench Frame (5). Insert the M10 x
115mm Bolt (55) through one side of the bracket.
Slide the 15mm x 10.2mm x 60mm Spacer (57) onto
the Bolt. Next, insert the Bolt through the other side of
the bracket and the other tube of the Backrest
Adjustment Bracket. Secure the Bolt with an M10
Washer (6) and an M10 Nylon Locknut (11). Do not
overtighten the Nylon Locknut.

17

28

28

6

11

36

Lubricate

6

Holes

Welded

Tube

28

28

22

27

18

6

36

57

5

11

6

55

27

Lubricate

Bracket

11