Image IMHS80081 - Manual (Page 10)

10
USING THE HYDROTHERAPY SPA
The hydrotherapy spa is designed for up to four
adults. The six water jets can be regulated to provide
a relaxing massage to sooth away stress, and the
strength of the water massage can be adjusted by the
air control. The hydrotherapy spa holds 300 gallons of
water and offers an automatic, programmable heating
(70¡F to 104¡F) and filtration system.
The guidelines below explain how to properly use the
hydrotherapy spa. Follow these guidelines to maintain
the spa for your long-term enjoyment.
PRIMING THE SPA JET UNIT
The water pump in the spa jet unit must be primed
before you use the hydrotherapy spa the first time.
You must also prime the pump before using the unit
each time you re-fill the hydrotherapy spa.
To prime the spa jet
unit, remove the
primer cap from the
console. Fill the spa
jet unit with at least 64
oz. of water. Replace
and tighten the
primer cap. IMPOR-
TANT: The spa jet
unit may be seriously damaged if the pump is not
properly primed, or if the primer cap is not
replaced and fully tightened.
PLUGGING IN THE HYDROTHERAPY SPA
Once the hydrotherapy spa is filled with enough water
to cover the water jets and the pump has been
primed, the power cord can be plugged in and the spa
jet unit can be turned on. Note: The first time the
power cord is plugged in, the spa jet unit will turn on
automatically.
When connecting the power cord, plug the power cord
directly into a grounded circuit capable of carrying 15
or more amps. No other appliance should be on the
same circuit. Replace the power cord immediately if it
becomes damaged.
The power cord is equipped with a Ground Fault
Circuit Interrupter (GFCI), located at the end of the
power cord. You should always test the GFCI before
using the hydrotherapy spa.
First, turn on the hydrotherapy spa by pressing the
power button on the console. Once the unit is run-
ning, press the GFCI ÒtestÓ button. The hydrotherapy
spa should shut off. Press the ÒresetÓ button. The
hydrotherapy spa should resume normal operation. If
the hydrotherapy spa continues to run after the ÒtestÓ
button is pressed, then the GFCI is damaged. Do not
use the hydrotherapy spa until the GFCI has been
repaired or replaced by a qualified electrician.
Test and Reset
Buttons
Grounded circuit capable of
carrying 15 or more amps
GFCI
Primer
Cap
7
1, 2
11
13
Latches and Buckles
7. Place the Spa Cover (11) over the Side Panels (1,
2) and the Spa Jet Unit (13). Be sure that the Spa
Cover is properly centered and that the straps
on the Spa Cover line up with the straps extend-
ing from the slots in the Side Panels (1, 2).
Snap each of the six latches on the Spa Cover (11)
into the buckles on the straps extending from the
slots in the Side Panels (1, 2).