InFocus C160 - Manual (Page 10)

8
If you prefer connecting your C180 to your computer with an optional
VESA cable, connect one end of the cable to the VESA port on your com-
puter, and connect the other end of the cable to the blue Computer 2 con-
nector on the projector.
You can control the projector from an LCD control panel or computer by
connecting an RS-232 cable to the projector’s Serial connector. Specific
RS-232 commands can be found in the Service and Support section of our
website.
The C180 can be managed by ProjectorNet networking software through its
Network
connector.
Contact an authorized dealer or visit our website for information on
ProjectorNet.
connect VESA cable
computer 2 network
monitor out
audio out
audio in L audio in
serial control
computer in
computer 1
video 2
video in
R S-video 1
connect RS-232 cable
computer 2 network
monitor out
audio out
audio in L audio in
serial control
computer in
computer 1
video 2
video in
R S-video 1
computer 2 network
monitor out
audio out
audio in L audio in
serial control
computer in
computer 1
video 2 video in
R S-video 1
Network
connect network cable