InSinkErator AQUASAVER AS-101K - Manual (Page 4)

4
Mounting the Control Center/Plumbing Connections
MOUNTING THE CONTROL CENTER
Use the flanges at the back of the control center
enclosure and only mount panel in the upright vertical
position (door hinge is on the left). See Figure 1.
Locate control center within sight of disposer per local
codes. Locate any remote control station within sight of
disposer per local codes.
If box is mounted to the sink table, recess the box so
that the buttons do not extend beyond the table’s edge.
PLUMBING CONNECTIONS
Two solenoid valves with flow control valves
pre-installed (1 GPM and 7 GPM) are packed with the
control center. The syphon breaker is supplied with all
complete disposer packages (packed separately).
The solenoid valve is supplied with a 24 V coil. Make
certain that the valves are plumbed according to the
water flow direction arrows marked on the valve or the
valves will not function properly.
The flow control valve regulates all water flowing into
the disposer. This conserves water and prevents
overloading. Check direction of water flow arrows.
Syphon breaker must be installed above the sink flood
plane
per local plumbing codes. Check direction of
water flow arrows.
Figure 2. Typical Installation Diagram
Figure 1. Control Center Dimensions
NOTE: The AS-101K control center requires the use
of two solenoid valves and two flow control valves.
Figure 2 shows the proper installation for an
AS-101K control center.
Sink Installation Trough Installation
9-7/8"
(250.8 mm)
8-1/4"
(209.6 mm)
15-3/4"
(400.1 mm)
5-5/16"
(134.9 mm)
15-1/8"
(384.2 mm)
14"
(355.6 mm)
1"
(25.4 mm)
6-3/4"
(171.5 mm)