Indesit WIDL 146 - Manual (Page 13)

13
GB
Troubleshooting
Service
Tr
oubleshooting
Precautions
Care
Programmes
Detergents
Installation
Description
Your washer-dryer could fail to work. Before calling for Assistance (see page 14), make sure the problem can't
easily be solved by consulting the following list.
Problem
The washer-dryer won't start.
The washer-dryer does not fill
with water.
The machine continuously fills
and empties with water.
The washer-dryer does not
drain or spin.
The washer-dryer vibrates too
much during the spin cycle.
The washer-dryer leaks.
The ON-OFF/DOOR LOCK Led
flashes rapidly at the same
time as at least one other LED.
There is too much foam.
The washer-dryer does not dry.
Possible causes/Solution:
• The appliance is not plugged into the socket, or not enough to make contact.
• There has been a power failure.
• The appliance door is not shut properly.
• The button has not been pressed.
• The START/RESET button has not been pressed.
NB: It should be held minimum one second.
• The water tap is not turned on.
• A delayed start has been set (using the Delay Timer, see page 9).
• The water inlet hose is not connected to the tap.
• The hose is bent.
• The water tap is not turned on.
• There is a water shortage.
• The water pressure is insufficient.
• The START/RESET button has not been pressed.
• The drain hose is not too low or too far in to the stand pipe (see page 3)
for correct installation.
• The wall drainage system doesn't have a standard pipe (min. 38 mm).
• Some programs have a slower final spin to taked best care of the
fabrics. See page 8 for details of the final spin speed for each program.
• The programme does not foresee the draining: some programmes
require enabling the draining manually (see page 8).
• The Easy iron option is enabled: to complete the programme, press
the START/RESET button (see page 9).
• The drain hose is bent (see page 3).
• Remove the drain hose from the standpipe or under-sink trap and
check for blockages, ensuring that the water can drain freely away
from the machine.
• Check that the transit bolts were removed correctly during installation
(carefully read pages 2 and 3).
• The washer-dryer is not level (see page 2).
• The washer-dryer is closed in between furniture cabinets and
the wall (see page 2).
• The water inlet hose is not screwed on correctly (see page 2).
• The detergent dispenser is obstructed (to clean it, see page 12).
• The drain hose is not secured properly (see page 3).
• Call for Assistance because this means there is an abnormality.
• The detergent is not suitable for machine washing (it should bear the
definition "for washing machines" or "hand and machine wash", or the like).
• You used too much detergent.
• The appliance is not plugged into the socket, or not enough to make contact.
• There has been a power failure.
• The appliance door is not shut properly.
• A delayed start has been set (using the Delay Timer, see page 9).
• the DRYING knob is on the 0 setting.