Infinity 3-Way Full Rang Floorstanding Speakers OVTR 2 - Manual (Page 5)

Figure 2. This cross-section shows
how to install a foot onto the bottom
of a Compositions Overture OVTR 2
or OVTR 3 speaker.
2. For carpets, screw the round end of a foot into each hole and hand-
tighten a nut onto each one (see Figure 2). Leave a minimum of 5 ⁄ 8 "
exposed spike to keep the carpet from blocking the port. (On thicker
carpets, you can increase the length of exposed spike up to 1
1 ⁄ 8 ").
For hard-surface floors, screw the spike end into each hole instead
and leave
5 ⁄ 8 " of round end exposed.
3. Carefully flip each speaker upright to sit on its feet.
4. If needed, adjust the feet so each speaker is level and then tighten
each nut with the enclosed wrench. To protect hard surfaces (e.g.,
wood floors), thread a nylon dome onto each round end (see Figure 2).
Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual ◆ 3
Nylon Dome
(optional for
wood floors)
Locking Nut
HARD-SURFACE
FLOORS
CARPETED
FLOORS
Foot
round end
spike end
Bottom
Of Speaker
5 ⁄ 8 " 5 ⁄ 8 " min.
1 1 ⁄ 8 " max.
Overture 2/3 Ins 9/11/98 4:23 PM Page 3