beautypg.com

Image Advanced 1400 IMTL07905.1 User Manual

Page 7

background image

7

3. Remove the knob from the pin. Make sure that the collar

and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin
into the Latch Housing (82), and tighten the knob back
onto the pin.

Knob

Collar

Spring

Pin

82

3

4. See drawing 4c. With the help of a second person, hold

the Console Base (101) near the Uprights (97). Look
under the Console Base and locate the wires on the
sides of the Console Base. Make sure that the wires are
not routed through the openings for the Trays (109,
111). Drawing 4a shows the correct route for the wires;
drawing 4b shows an incorrect route.

See drawing 4c. Locate the Wire Harness (74) and the
pulse wire in the Uprights (97). Cut the plastic ties secur-
ing the Wire Harness and the pulse wire.

Connect the Wire Harness (74) and the pulse wire to the
connectors on the sides of the Console Base (101).
Make sure to connect the connectors properly (see
the inset drawings). The connectors should slide to-
gether easily and snap into place.
If the connectors do
not slide together easily and snap into place, turn a con-
nector and try again to insert it.

IF THE CONNECTORS

ARE NOT CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS TURNED
ON.
Insert the excess Wire Harness and pulse wire up
into the Console Base.

101

97

97

4c

74

Pulse

Wire

4a

4b

Correct

Incorrect

74

2. With the help of a second person, carefully tip the

Uprights (97) down as shown. (Note: It may be helpful to
place one foot on one of the Extension Legs [92] as you
tip the Uprights.)

Make sure that the Extension Legs

remain in the Uprights.

Attach the Extension Legs (92) with four 1” Tek Screws
(80) and two Base Pads (99) as shown.

Tighten the Tek

Screws without the Base Pads first. Note: The indi-
cated center holes are not used.

Attach the other two Base Pads (99) to the base of the
Uprights (97) in the locations shown with two 1” Tek
Screws (80).

With the help of a second person, raise the Uprights (97)
to the vertical position.

80

80

80

99

92

80

80

92

97

99

Not

Used

Not

Used

97

2

99

99

109

111