Ironman Fitness Aeros - Manual (Page 5)

5
Getting Started - The Ironman Fitness Aeros Elliptical will require some assembly. Unpack
the box in a clear area. Remove packing material. Do not dispose of packing material until
assembly is complete and unit is working properly. Place the unit on a clean level surface for
assembly. Make sure there is easy access to an electrical outlet. Before assembling the unit
should be placed as close as possible to its final location. Tools have been provided for use
while assembling this product.
Assembly
Figure 1
Step 1
Secure Rear Stabilizer to
the Main Frame using Four
M8x1.25-16 Screws and
M8.2x18-2 Flat Washers on
the top four holes, and Three
M10x1.5-20 Bolts and M10x20-2
Flat Washers on the three holes
located on the bottom of the
Rear Stabilizer.
M10X1.25-20 BOLT
M8X1.25-16 BOLT
M8.2X18-2 FLAT WASHER
REAR STABILIZER
Figure 1
RIGHT HANDRAIL
LEFT HANDRAIL
M5X0.8-12MM SCREW
COVER
M8X1.25-16
SCREW
Figure 2
Step 1:
Secure Left Handlebar to
Main Frame using Four M8x
1.25-16 Screws. Attach the
Cover over the Handlebar and
secure using Two M5x0.8-
12mm Screws. Repeat again
using the Right Handlebar.
Figure 2
M10x20-2 WASHER