beautypg.com

Image IMTL41205.0 User Manual

Page 7

background image

9.

Make sure that all parts are properly tightened before
you use the treadmill.
Note: Extra hardware may be in-
cluded. Keep the included allen wrenches in a secure
place; the large allen wrench is used to adjust the walk-
ing belt (see page 14). To protect the floor or carpet,
place a mat under the treadmill.

13

14

1

76

46

10

21

6.

Touch the Right Upright (62) to discharge any static.
Insert the connector on the end of the Wire Harness (21) into
the socket beneath the console.

The connector should

slide easily into the socket and snap into place. If the
connector does not slide easily and snap into place, turn the
connector and then insert it.

Make sure that the connec-

tors and wires appear as shown in drawing 6a.

Next, insert the excess Wire Harness (21) down through
the opening in the Console Base (46). See the inset draw-
ing in step 5.

Securely tighten the plastic tie on top of

the Console Base to prevent the Wire Harness from
slipping.
Then, cut off the end of the plastic tie. See draw-
ing 6b.

Press the Bookrack (90) onto the Console Base (46) in the
location shown.

Set the Console (10) on the Console Base (46). Insert the ex-
cess Wire Harness (21) into the large hole in the side of the
Right Handrail (47).

Securely tighten the plastic ties on the

bottom of the Console Base to prevent the Wire Harness
from slipping.
Then, cut off the ends of the plastic ties.

Attach the Console (10) to the Console Base (46) with four
1/2” Screws (97) and two 3/4” Screws (13).

Start all six

Screws before tightening any of them; do not over-
tighten the Screws.

6

8

62

97

97

97

13

13

47

Ties

7

21

46

90

6b

6a

8. Attach the Storage Latch (14) to the left Upright (76) with two

3/4” Screws (13).

Be careful not to overtighten the Screws.

7. Lower the Uprights (62, 76) until the Handrails (47) are

touching the floor.

See the lower drawing. Position the Uprights (62, 76) so
the treadmill Frame (75) is centered between them.

Firmly tighten the four 2 1/4” Bolts (78) and all other
bolts and screws used in assembly steps 3, 4, 5, and 6.

Connector

76

62, 76

47

75

62

Top View

7

78