Indesit IDL 530 - Manual (Page 8)

6
EN
Turning on the Appliance
First of all.
Turn on the water tap completely and press ON-OFF
button "A". you will hear a short beep and indicator light
"B" lights up.
Now the appliance is on and awaiting instructions.
Starting and selecting the cycle.
Turn the cycle selector knob "D" clockwise until the
reference notch on the knob corresponds with the number
or symbol for the cycle you wish to set (consult the wash
cycle table on page 7, especially when first using the
appliance).
If the appliance door is shut, press the Start button "R"
and you will hear a beep; the cycle will start up within a
few seconds.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "G" which
come on in sequence as the appliance is performing that
specific phase of the wash cycle.
These phases are:
pre-wash, wash, rinses, drying
Cancelling or modifying a wash cycle in progress ..
Premise: You can cancel the wash cycle in progress, if it
has only just started.
To modify a wash cycle, keep the RESET button "R"
pressed for about 5 seconds: a prolonged beep will sound,
followed by three short beeps. Indicator light "G" will turn
off and at this point, all the settings will have been
cancelled.
To select a new wash cycle, repeat the operations
illustrated in the paragraph entitled "starting and selecting
the cycle"
Warning: the knob must be turned clockwise from
wash cycle 1 to 5, an anti-clockwise from wash cycle 5
to 1.
If you have left out a dish
You can interrupt a wash cycle by pressing the ON-OFF
button, then place the dishes you had left out into the
appliance, which will start up from where it was interrupted
when you turn it back on.
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when the door is shut.
At the end of the wash cycle .
The end of the wash cycle is indicated by two short beeps
and the flashing of the drying phase indicator light.
• Turn off the water tap.
• Wait a few minutes before unloading the dishes: if you
wait a little while, they dry better thanks to the steam.
• Empty the lower rack first.
Warning: when you open the dishwasher door after
the wash cycle has just ended or is under way, take care
not to scald yourself with the hot steam.
Warning:
Turn the appliance off by pressing button " A ", unplug
the appliance from the electricity socket to cut off the
power supply; the power supply cable should
consequently be easily accessible.