Integra CROMA24 User Manual
Croma24, Color printer service manual
Table of contents
Document Outline
- Table of Contents
- Chapter 1 General Description
- Chapter 2 Theory of Operation
- Chapter 3 Maintenance
- Introduction
- Scheduled Maintenance
- Servo Motor Winding Resistance Check
- Stepper Motor Winding Resistance Check
- Banding: Hardware vs Software
- Alignments/Adjustments
- Croma24 Control Panel
- Built In Test (BIT)
- Firmware/Software Upgrades
- Internal Cabling and Signal Flow Diagram
- Chapter 4 Troubleshooting
- Chapter 5 Assembly\Disassembly
- Introduction
- Remove the Left, Middle (Lid), and Right Covers
- Install the Left, Middle, and Right Covers
- Remove the MPCB (Main Printed Circuit Board) and Actuator Assembly
- Install the MPCB and Actuator Assembly
- Remove Servo Motor
- Install Servo Motor
- Remove the Carrier Assembly, Carrier Belt, and the Frame Tensioner
- Install the Carrier Assembly, Carrier Belt, and the Frame Tensioner
- Remove the Carrier PCB
- Install the Carrier PCB
- Remove the Paper Sensor or the Encoder Sensor
- Install the Paper Sensor or the Encoder Sensor
- Remove the Trailing Cable Cover Assembly
- Install the Trailing Cable Cover Assembly
- Replacing the Carrier Bushings
- Remove the Service Station, Seals, and Wipers
- Install the Service Station, Seals, and Wipers
- Remove the Lower Roller Assembly and Stepper Motor
- Install the Lower Roller Assembly and Stepper Motor
- Remove the Power Supply and AC Entry Module
- Install the Power Supply and AC Entry Module
- Chapter 6 Parts List
- Index