Control assembly/disassembly, Control disassembly, Control assembly – Ingersoll-Rand FE074B( )A( ) User Manual
Page 9
M107
26
9
76*
104
105
94
95
96
f
97
f
98
97
f
106
107
108
109
94
95
f
96
112
99
100
101
103
f
102
110
111
49674 CONTROL ASSEMBLY
* NOT INCLUDED IN ASSEMBLY
1/8–27 NPT
f
INCLUDED IN 49596 SERVICE KIT.
CONTROL DISASSEMBLY
_
Control valves (100) and needle valves (103) can be serviced
without removing the control assembly from the tool.
_
Remove three screws (112), releasing face plate (99).
_
Pull control valves (100) from valve body (106).
_
Unthread and remove needle valves (103).
_
To further disassemble, remove five cap screws (76), releas-
ing control assembly from the tool.
_
Remove retaining rings (94) and end caps (95) and push
spool (98) out of valve body (106).
CONTROL ASSEMBLY
_
Lubricate all ‘‘O” rings with ARO 36460 lube when assem-
bling.
_
Assemble ‘‘O” rings (96) to grooves in end caps (95).
_
Assemble one end cap (95) to valve body (106), securing with
retaining ring (94).
_
Assemble ‘‘O” rings (97) to grooves in spool (98) and as-
semble spool into valve body (106).
_
Assemble end cap (95) to valve body, securing with retaining
ring (94).
_
Assemble ‘‘O” rings (102) to grooves in needle valves (103)
and thread needle valves into valve body (106).
_
Grease ‘‘O” rings on control valves (100) and assemble into
valve body (106).
_
Assemble face plate (99) to valve body, securing with three
screws (112).
_
Assemble control assembly to tool, securing with five cap
screws (76).
FORWARD / START
PUSHBUTTON
RETRACT / EMERGENCY
RETRACT PUSHBUTTON
RETRACT FEED RATE
ADJUSTMENT KNOB
Q
FORWARD FEED RATE
ADJUSTMENT KNOB
Q
EXHAUST, FEED CYLINDER
MAIN AIR INLET (1/8–27 N.P.T.)
Q
TURN ‘‘IN” TO DECREASE FEED RATE.
TURN ‘‘OUT” TO INCREASE FEED RATE.