IMC Networks Wireless Outdoor Bridge XI-1500-IH - Manual (Page 11)

TTestMacAddress-fill MacAddress of remote AP.
Transmit Pkt Num-display the number of frame be sended.
RcvPkNumLabel-display the number of frame be received.
Recv/Trans Rate-display the successful rate of transmitting.
Time Elapsed-show the time cost of sending data.
Local Signal Level
show local signal level.
Remote Signal Level show remote signal level.
Note: View the intensity of signal, and adjust the positions and angles of the antenna
according to the intensity of signal. Adjust the antenna from side to side from head
to foot, observe the number value of signal level at the same time , when the number
value is 100%, the antenna is in the best positions and angles promptly.
Start
click it will begin test link
Stop click it to stop test link.
Close click to stop test link.
Channel test the channel quality.
Note: channel quality test must be perform after TX/RX data in gear, click “stop”
and the “channel” will be enable, click it to enter test window, be sure the MAC
Address of the remote Wireless Outdoor Bridge is right.
Start click it start channel quality test.
Stop click stop channel quality test.
Cancel cancel test.
Set Channel set the channel to the best one, remember click “Apply”.
Note: Two Wireless Outdoor Bridge’s channel will be reset after apply set channel.
11