Image IMTL11997 User Manual

Page 19

If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the Speed or Incline buttons on
the console. However, when the next “chirp” is
heard, the speed and/or incline will change to
the next settings of the CD or video program.

To stop the walking belt at any time, press the
Stop button on the console. The Time/Laps dis-
play will begin to flash. To restart the program,
press the Start button or the Speed + button. After
a moment, the walking belt will begin to move at
1.0 mph. When the next “chirp” is heard, the
speed and incline will change to the next set-
tings of the CD or video program.
When the CD or video program is completed, the
walking belt will stop and the Time/Laps display will
begin to flash. Note: To use another CD or video
program, press the Stop button or remove the key
and go to step 1 on page 18.

Note: If the speed or incline of the treadmill
does not change when a “chirp” is heard:

• Make sure that the iFIT.com indicator is lit and

that the Time/Laps display is not flashing. If
the Time/Laps display is flashing, press the
Start button or the Speed + button on the
console.

• Adjust the volume of your CD player or VCR.

If the volume is too high or too low, the con-
sole may not detect the program signals.

• Make sure that the audio cable is properly

connected, that it is fully plugged in, and that
it is not wrapped around a power cord.

• If you are using your portable CD player and

the CD skips, set the CD player on the floor or
another flat surface instead of on the console.

• See the instructions near the bottom of page

24.

Follow your progress with the LED track and
the displays.

See step 5 on page 11.

Measure your heart rate, if desired.

See step 6 on page 12.

When the program is completed, remove the
key.

See step 6 on page 13.

CAUTION: Always remove iFIT.com CDs and
videocassettes from your CD player or VCR
when you are finished using them.