Image 831.297570 - Manual (Page 15)

Press the RECORD button and program the de-
sired speed and incline settings.
When the RECORD button is pressed, the indicator
on the button will light. Speed and incline settings
can be programmed only when the indicator on
the button is lit.
Refer to the
LED matrix.
Each custom
program is
divided into
one-minute
segments. One
speed setting
and one incline
setting can be programmed for each one-minute
segment. The speed setting of the first segment is
shown in the flashing column of the LED matrix.
(The incline settings are not shown in the LED ma-
trix.) To program the desired speed and incline set-
tings for the first segment, simply adjust the speed
and incline of the treadmill to the desired levels with
the SPEED and INCLINE buttons. Every few times
the SPEED “+” or “–” button is pressed, an additional
LED will light or darken in the flashing column.
When the first one-minute segment of the program
is completed, the current speed setting and the cur-
rent incline setting will be stored in memory. All
columns in the LED matrix will then move one posi-
tion to the left, and the speed setting of the second
segment will be shown in the flashing column.
Program speed and incline settings for the second
segment as described above.
Repeat this procedure until you have programmed
speed and incline settings for as many segments as
desired. Custom programs can have from one to
forty segments. When you are finished, hold down
the STOP button for two seconds. The speed and in-
cline settings you programmed and the number of
segments will then be stored in memory. To use the
program again, see HOW TO USE A CUSTOM PRO-
GRAM at the right.
Note: To pause the program temporarily while you
are programming speed and incline settings, press
the STOP button once. All displays will pause and the
TIME display will begin to flash. To restart the pro-
gram, press the START button.
Remove the key from the console.
When the program has ended, remove the key from
the console. All displays and indicators on the con-
sole will darken.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page 9.
Select one of the custom programs.
To select one of the
custom programs,
press the CUSTOM
PROGRAM 1 or
CUSTOM PROGRAM
2 button. The letters
“CP 1” or “CP 2” will
appear in the SPEED/
PACE display to show which program is selected.
When a custom program is selected, the LED matrix
will show the speed settings of the program. If the
program is more than twenty minutes long, only the
first nineteen settings will be shown. The first column
will be flashing. Note: Every few seconds, the words
“PRESS START” will scroll across the LED matrix.
Enter your weight and age if desired.
It is not necessary to enter your weight and age to use
a custom program; however, the CALORIES display
will be more accurate if these numbers are entered.
To enter you weight and age, refer to step 3 on
page 10. If you have already entered your weight
and age, or if you do not want to enter this informa-
tion, go to step 4.
Press the START button.
Press the START button to start the program. After a
moment, the walking belt will begin to move. Hold
the handrails and begin walking.
Refer to the
LED matrix.
Each custom
program is di-
vided into one-
minute seg-
ments. One
speed setting
and one in-
cline setting are programmed for each segment. The
speed setting of the first segment is shown in the
flashing column of the LED matrix. The speed set-
tings of the next six segments are shown in the six
columns to the right. (The incline settings are not
shown in the program display.)
5
1
2
3
4
6
HOW TO USE A CUSTOM PROGRAM
15