beautypg.com

Using ip38, Using the alarm – iHome IP38 User Manual

Page 7

background image

Using iP38

4

Setting Time and Clock Display Format

1. Press and hold the Button (located to the left of the display in the battery compartment) for 2 seconds until the

display flashes.
2. Press + or Button to select 12 Hour or 24 hour clock display format. Press the Button again for clock setting.
3. Press

+ or Button to adjust to correct time. Hold the buttons for a few seconds to advance or reverse rapidly.

Remember to set the correct AM or PM time. The PM Indicator is located on the upper right hand side of the time digits;

there is no AM indicator).

Using Time Sync to Set Clock from iPhone/iPod

The iP38 allows you to sync its clock with the time from your iPhone/iPod.
1. Make sure the iP38 is off. Dock your iPhone/iPod into the iP38 using the proper insert (see table on page 1).
2. Press the Button. “SYNC” will flash on the display until sync is completed. Two beeps will indicate sync is complete.

Note: the iPhone cannot sync to exact seconds; you may see up to 59 seconds difference between iP38 and synced

iPhone/iPod.

Using the Alarm

Setting the Alarm

1. Press and hold the Button until the current alarm time flashes.
2. Press the + or - Button to set the desired alarm time. Hold the buttons for a few seconds to advance or reverse rapidly.

Remember to set the correct AM or PM time.

2. Press the Button to confirm alarm time (or no button press within 10 seconds) to exit alarm setting mode.

The alarm will be armed and the alarm icon will remain on the display, indicating the alarm is active.
3. If no iPhone/iPod is docked or detected, the iP38 will automatically change to buzzer alarm.

Reviewing and Turning Alarm Function On and Off

1. Press the Button once to review the set alarm time. This also toggles the alarm off (the alarm icon will disappear).
2. Press the Button again to re-arm the alarm; the alarm icon will appear again in the display.

Resetting the Alarm to Come on the Next Day

1. When the alarm is sounding, press the Button to stop the alarm and reset it to come on the following day.