Integra DPS-5.3 - Manual (Page 15)

15
Before connecting
• The DPS-5.3 is shipped with the main power (Power)
switch in the on position ( _On). When the power cord is
plugged in for the first time, the DPS-5.3 will automatically
enter the standby state and the Standby indicator will light
(same condition after step 2 below).
• Make sure that all the connections on pages 13 and 14 are
complete (the connection to a TV is required).
Connecting the Power/
Turning on the DVD Player
AC INLET
1
2
Power
To the mains
STANDBY/ON
POWER
3
Press Standby/On on the DVD
Player or ON on the remote
controller.
The DVD Player turns on and the Standby
indicator turns off.
• To put the DVD Player in the standby
mode, press Standby/On on the DVD
Player, or STANDBY on the remote
controller. Be sure to set the volume to
minimum before putting the DVD Player
in the standby mode for the next use to
avoid sudden loud sound reproduction.
• While the Standby indicator lights up,
the DVD Player can receive signals from
the remote controller. However, if you
press Power on the DVD Player to
switch off the main power, the remote
controller cannot be used to turn on the
DVD Player.
• Setting the STANDBY button to standby
does not shut off the power completely.
Standby/On Plug the supplied power cord into
the AC INLET and then into the
power outlet on the wall.
• Do not use a power cord other than the
one supplied with the DPS-5.3. The
power cord supplied is designed for use
with the DPS-5.3 and should not be
used with any other device.
• Never have the power cord
disconnected from the DPS-5.3 while
the other end is plugged into the wall
outlet. Doing so may cause an electric
shock. Always connect by plugging into
the wall outlet last and disconnect by
unplugging from the wall outlet first.
Press Power to switch on the main
power.
The DVD Player enters standby mode.
The Standby indicator lights up.
• The buttons on the remote controller do
not operate if the Power switch is set to
Off.
• To switch off the main power, press
Power again.