Infinity CASCADE FIFTEEN - Manual (Page 6)

3 CASCADE MODEL FIFTEEN
C
ONNECTIONS
If you have a Dolby ® Digital or DTS ® receiver/processor
with a low-frequency-effects (LFE) output:
• Set Normal/LFE Switch to LFE.
NOTE: In this case, you do not need to use a Y-connector. Simply
connect the LFE output on your receiver/processor to either the
left or right input on the subwoofer.
The Cascade Model Fifteen also includes a set of line outputs. These
outputs allow you to “daisy-chain” one Model Fifteen to multiple Model
Fifteen subwoofers. Simply connect the first subwoofer as described
above and then run a subwoofer cable from the line output(s) to the
line input(s) on the next sub.
NOTE: This line output is before the R.A.B.O.S. circuit. Each sub-
woofer’s R.A.B.O.S. controls must be individually adjusted during the
R.A.B.O.S. setup.
SUBWOOFER OR
LFE OUTPUT
If your receiver/processor has subwoofer
outputs for the left and right channels:
• Set Normal/LFE Switch to Normal.
NOTE: Some receivers have a single subwoofer output (do not confuse
this with a single LFE output as described to the left). In that case, it is
recommended that you use a Y-connector (not included) to maximize
performance.
SUBWOOFER OR
LFE OUTPUT
OR
Cascade 15 OM 9/14/05 2:35 PM Page 6