beautypg.com

Image IMBE53900 User Manual

Page 10

background image

10

13. Press a 50mm x 70mm Outer Cap (10) onto each

end of the Stabilizer (13).

Attach the Stabilizer (13) to the Bench Frame (5)
with two M10 x 60mm Button Head Bolts (12) and
two M10 Nylon Locknuts (11). Note: There is an
indentation around each hole on one side of the
Stabilizer; this side must be facing the floor so
that the warning decal is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

13

12

10

11

5

13

Decal

10

14. Press a 50mm Square Outer Cap (20) onto each

end of the Bench Base (7).

Attach the Bench Base Joint Plate (19) to the Bench
Base (7) with two M10 x 70mm Bolts (21), two M10
Washers (6), and two M10 Nylon Locknuts (11).

Attach the Bench Leg (1) to the Bench Base Joint
Plate (19) with two M10 x 70mm Bolts (21), two M10
Washers (6), and two M10 Nylon Locknuts (11).

Be sure the welded nut is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

14

21

6

6

21

6

6

1

Welded Nut

11

19

20

20

7

12. Attach the upper end of one of the Weight Guides

(53) to the bracket on the Upright (43) with an M8 x
30mm Bolt (64) and an M8 Washer (77).

Attach the other Weight Guide (53) to the other
Upright (43) in the same manner.

Tighten all of the Locknuts used in steps 1 to 12.

64

53

77

43

12

15. Attach the Bench Leg (1) to the Bench Frame (5)

with two Bench Joint Plates (18), four M10 x 70mm
Bolts (21), and four M10 Nylon Locknuts (11).

Note: Tighten all the M10 Nylon Locknuts (11)
used in steps 13-15.

15

1

11

18

5

21

18