Iiyama PROLITE B2403WS - Manual (Page 9)

ENGLISH
BEFORE YOU OPERATE THE MONITOR 5
Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped. „
Do not give a strong impact to the monitor. It may cause damage. „
Unplug the monitor before removal or installation to avoid electric shock or damage. „
The monitor is supplied complete with a stand. If you prefer to wall mount the monitor, please follow
the instructions below to remove the stand. Be sure to include the stand with the monitor if it is
necessary to return the unit.
CAUTION
A Put a piece of soft cloth on the table
beforehand to prevent the monitor from
being scratched. Lay the monitor flat on a
table with front face down.
B Insert stand into the monitor as shown in
figure as action ‘2’.
C To secure stand, gently lower base as
shown in figure as action ‘3’ until stand
locks.
A Put a piece of soft cloth on the table
beforehand to prevent the monitor from
being scratched. Lay the monitor flat on a
table with front face down.
B Press release button as shown in figure
as action ‘2’.
C Keeping release button pressed, lift base
as shown in figure as action ‘3’.
D Remove the stand.
FITTING AND REMOVAL OF BASE
A Put a piece of soft cloth on the table
beforehand to prevent the monitor from
being scratched. Lay the monitor flat on a
table with front face down.
B The Stand-Bottom is pulled up as shown in
the figure.
C Install the Stand-Base to the Stand-Bottom.
A Put a piece of soft cloth on the table
beforehand to prevent the monitor from
being scratched. Lay the monitor flat on a
table with front face down.
B Hold down the hooks outside and pull the
Stand-Base away from the Stand-Bottom.
ProLite B2403WS
ProLite E2403WS
PLB_E2403WS-e-M021B01.P65 2007/09/03, 9:54 9