Indesit PI604GB - Manual (Page 3)

GB
3
Electrical connection
The following installation procedure must be carried
out by a qualified electrician.
! the cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the hob
Rating Plate. All electrical wiring from the consumer
unit to the appliance, via the switched double pole
cooker outlet, must be of an acceptable type and
current rating as above. The supply cord, type H05
VV-F 3x2.5mm 2 , must be positioned so that it never
reaches at any point a temperature 50°C higher than
the room temperature. The electrical installation must
comply with the IEE Regulations, Building Regulation
& local By-Lays.
! THIS APPLIANCE MUST BE EARTHED.
In the case of installation over a built-in electric oven
the electrical hook-up of the stove top and that of the
oven should be separate, for reasons of safety as well
as for ease of eventual removal of the oven.
Supply cable installation
The electrcic hobs are supplied without cable. Use a
cable:
H05 VV-F 3x2.5mm 2
• Open the terminal box by removing the "V" screw
and taking off the cover.
• The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow - Earth “E”
Blue - Neutral “N”
Brown - Live “L”
Connect the wires in accordance with the following
diagram
3 2 1 5 4
N L
• Fix the cable in place with the "F" cable clamp,
close the lid and fasten it with the "V" screw (see
picture).
F
V
1 2 3 4 5