Invacare RPS350-1 - Manual (Page 14)

SECTION 4—LIFTING THE PATIENT
Stand Up Patient Lift 14 Part No. 1078984
SECTION 4—LIFTING THE PATIENT
ƽ WARNING
DO NOT exceed the maximum weight limitation of 350 lbs.
DO NOT attempt to any transfer without approval of the patient’s physician, nurse or medical
assistant.
ALWAYS keep hands and fingers clear of moving parts to avoid injury.
Invacare patient slings are made specifically for use with Invacare patient lifts. For the safety of the
patient, DO NOT intermix patient slings and patient lifts of different manufacturers.
Individuals that use the standing patient sling MUST be able to support the majority of their own
weight, otherwise injury may occur.
The legs of the stand-up lift MUST be in the maximum open position and the shifter handle locked in
place for optimum stability and safety. If the patient is in a sling and it becomes necessary to move
through a narrow passage, close the legs of the stand-up lift only as long as it takes to move through
the passage. Once the stand-up lift is through the passage, return the legs of the stand-up lift to the
maximum open position and lock the shifter handle IMMEDIATELY.
DO NOT move the patient if the patient sling is not properly connected to the attachment points on
the patient lift. Check that the patient sling is properly connected to the attachment points BEFORE
lifting the patient.
During transfer, with the patient suspended in the patient sling, DO NOT roll the base of the patient
lift over any uneven surfaces that would cause the patient lift to become unstable.
Use the steering handle on the mast assembly at all times to push or pull the stand up lift.
Positioning the Stand Up Lift
NOTE: For this procedure, refer to FIGURE 4.1.
NOTE: Refer to General Guidelines on page 8 before proceeding and observe all warnings indicated.
NOTE: Before positioning the legs of the patient lift under a bed, make sure that the area is clear of any obstructions.
1. Ensure the legs of the stand up lift are in the maximum
open position. If not, use the shifter handle to open the
legs.
2. Position the stand up lift using the mast handle.
3. Press the DOWN button on the hand control to lower the
lift arms for easy attachment to the sling.
FIGURE 4.1 Hand Control Buttons
DOWN Button UP Button
Hand Control