IOGear G-CS14 - Manual (Page 10)

OperationOperation
Controlling the PCs in your MiniView TM configuration
from a single console couldn’t be easier. Two port
selection methods provide instant access to any
attached PC:
Manual Port Selection
Hot Key Port Selection
Note: When powering-on, the MiniView
TM switches to port 1
by default. If the PC attached to port 1 is inactive, the
monitor will be blank so it may appear as if the unit is not
functioning. This is not the case. Simply use one of the port
selection
methods described below to switch to the active PC on a
different port.
Manual Port Selection
With manual port selection, you simply press the Port
Selection button on the
side panel of the MiniView
TM to switch between computers.
The selected LED on the top panel will light up to indicate
which port is active.
Operation Operation
6 6
